Went to do my first ever gray this morning. Reconstituted 30mg vile last evening with 100 units water and it didn't want to dissolve fully, so I rolled it around while watching TV. Put it in refer till this morn and it was completely dissolved. Had put the 100 units in with a 1ml/29 gauge/1/2 length syringe and didn't notice any problems with that.. Went to load a .3ml/31guage/5/15inch syringe and could not get it to draw any liquid at all. Switched to a new 1ml/29 Guage/1/2inch length and had to push inward very firmly to have needle penetrate deep enough to draw fluid. It's as if the rubber cap is way too thick for 5/16 and barely let's 1/2 inch penetrate far enough or more likely I was to bleary eyed to get it right, Not a morning person and I'd had no coffee by then. Can somebody point me in the right direction. I only used .12ml, half my .25ml(7.5mg) dose to see any reactions. If none I'll do the other half in a couple days. ThanX
